Jacobsen AR-3 Technical/Repair Manual page 176

25
Figure 5-38
NOTE
Record the order of brake disks and stator rings to
ensure correct assembly.
13. Remove five brake disks (23) and six stator rings (24)
from the mounting flange assembly (25).
27
Figure 5-39
NOTE
Always replace the stator rings and brake discs as a set.
14. Inspect the friction surfaces (27) (front and rear).
Replace the stator rings (26) if the surfaces are worn
or damaged, or if any other damage is noted.
4181384 First Edition
23
24
TN1316
15. Inspect the disks for any scratches on the mating
26
TN1319
Record the orientation of the brake piston (30) and spring
discs (33) before removing to ensure correct installation.
16. Apply compressed air to vent (34), and remove the
HYDROSTATIC POWER TRAIN
28
Figure 5-40
surfaces (29) (front and rear). Replace the disks (28)
if any damage is noted.
30
31
32
Figure 5-41
NOTE
brake piston (30), O-rings (31 and 32), and two
spring disks (33) from the mounting flange (35).
29
TN1320
5
33
34
35
TN1339
5-29