2-Thread Rolled Hem - Bernina Overlocker L 890 Workbook

Hide thumbs Also See for Overlocker L 890:

Table of Contents

My BERNINA

2-THREAD ROLLED HEM

Lightweight fabric, 5" x 10"

80/12 ELX705

3 Spools Serger Thread (R,G)

2-Thread Rolled Hem Stitch #13

C 11

B E R N I N A O V E R L O C K E R W O R K B O O K

For this exercise, the overlocker will be threaded for a

2-thread rolled hem stitch using the right needle and

threaded with colors to match the color-coded threading

path on the overlocker.

Note: If following the order of activities in this Mastery

book, the right needle was inserted and threaded, and

the left needle and thread was removed in the previous

exercise. If so, you will skip Steps 2 and 3.

Select Stitch #13 and follow the steps in Guided Mode

or make the noted manual settings in Expert Mode.

Using the small screwdriver and needle holder tool,

loosen the right needle screw and insert the right

needle. Tighten the needle set screw. Thread the needle.

Remove the left needle thread. Loosen the left needle

set screw and remove the left needle.

Attach the Upper Looper Converter to the upper looper

See Diagram below.

Disengage the stitch finger by placing the Rolled Hem

Selection Lever in the "R" position.

Start the machine and run a chain for several inches so

that you have a thread tail to hold as an aid in getting

the fabric started.

Place the fabric under the presser foot and sew along

one 10" edge, trimming about 1/4" from the raw edge.

Return stitch length and thread tensions to their normal

setting.

Return the Rolled Hem Selection Lever to normal

sewing position.

Table of Contents