Toshiba RAS-B10J2FVG-E Service Manual page 76

4. In case of lattice establishment
• Follow the following fi gure, make sure to keep enough distance
between lattice, frame and wall.
• Be sure to switch to wall burying mode.
• The lattice should be make of wood.
• Between the air inlet and outlet, should be devided with partition board.
• Be sure to establish the open part for RECEIVER.
• The open part of lattice must be opens 70 % or more of the wall hole.
• The open part of lattice must be arranged uniformly.
(Top view)
Partition board
(Front view)
800 or more
50 or more
(Side view)
(Unit : mm)
70 or more
Opening for receiver
Partition board
50 or more
Opening for receiver
20 to 30
Partition board
- 76 -
10-3-5. How to open the air inlet grille
• Gripe the air grille inlet by two hands at the handle positions.
• Pull the air inlet grille as the arrow direction.
Air inlet grille
• The rope at the backside of air inlet grille is using for handle it on the front panel
when you need to clean up the air filter.
10-3-6. How to use the heat insulation block
• Completely fill pipe by heat insulation block to protect water dew.
• Heat insulation block can cut to an appropriate size and use.
Hook of front panel
Rope
Heat insulation block