Toshiba RAS-B10J2FVG-E Service Manual page 61

Air conditioner split type
Hide thumbs Also See for RAS-B10J2FVG-E:
Table of Contents

Advertisement

Notes
1. Place the remote control where the indoor unit can receive the signal. This will increase the accuracy of the timing between the remote control and the air
conditioning unit.
2. The ON/OFF timer can be set during the WEEKLY TIMER operation. In this situation, the air conditioner will f rst follow the normal timer until it is complete;
then, it will return to the WEEKLY TIMER function.
3. During WEEKLY TIMER operation, all of operation such as MODE, TEMP, FAN, Hi-POWER, ECO and etc., can be adjusted but when the clock reaches the
program setting, the operation will return to the set items in the program.
4. When the remote control is sending a signal to the air conditioner, avoid interference from objects that can block the signal.
5
Press
to select desired operation.
6
Press
or
l The temperature can be set between 17°C and 30°C.
7
Press
to select the desired fan speed.
Add operations, if required.
8
Press
to use 8°C operation. (Notes: Fireplace cannot select and memorize in weekly
l
function)
l Press
to use ECO operation
l Press
to use Hi-POWER operation.
l Press
to use SILENT CDU
Press
to use FLOOR
l
Adding or editing the program.
9
The program can be set to perform on all the required days until
setting !.
If adding or editing a program is required, please repeat steps 2 - 8 before setting conf rmation.
!
After adding or editing, press
Weekly timer running
Next program
Timer ON or OFF
Next operation time
*Point remote control at air conditioner receiving module then, press SET button until you hear
the "PiPi" sound. This means the setting operation has been completed.
As the air conditioner is receiving the signal, you will hear separate "Pi" sounds corresponding to
the number of days in the selected setting.
An incomplete setting is indicated if the TIMER lamp is blinking. Press
- 61 -
to select desired temperature.
to conf rm the setting*.
Operating Mode
Display after
pressing SET button
Operating Temperature
and Fan speed
is pressed to conf rm the
twice.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents