Remote-A Or B Selection; Quiet Mode; Comfort Sleep - Toshiba RAS-B10J2FVG-E Service Manual

Item
18. Remote-A or B Setting the remote controller
selection
To separate using of remote control for each indoor
unit in case of 2 air conditioner are installed nearly.
Remote Control B Setup.
1) Push and hold CHECK button on the Remote
Control by the tip of the pencil. "00" will be shown
shown on the display. (Picture
2) Press
show on the display and "00" will disappear and
the air conditioner will turn OFF. The Remote
Control B is memorized. (Picture )
Note : 1. Repeat above step to reset Remote Control

19. QUIET mode

When the "Quiet mode" selected from [ FAN ] button;
The fan of the indoor unit will be restricted the
-
revolving speed at speed UL.
The compressor speed is controlled as shown
-
in the figure.
Model
Cool/Heat min
Quiet Cool (Hz)
Quiet Heat (Hz)
When is cancel "Quiet mode". The [ FAN ] is
selected other speed.
20. COMFORT
Cooling mode
SLEEP
• The preset temperature will increase as
show on ECO operation (Item No. 9)
• Press the [COMFORT SLEEP] button to
choose the operating hours. Repeat
pressing to select the hours.
(1hr, 3hr, 5hr or 9hr)
• If the [COMFORT SLEEP] button is pressed
again means cancel comfort sleep mode.
Heating mode
• The preset temperature will drop down as
show on ECO operation (Item No. 9)
• Press the [COMFORT SLEEP] button to
choose the operating hours. Repeat
pressing to setect thehours.
(1hr, 3hr, 5hr or 9 hr)
• If the [COMFORT SLEEP] button is pressed
again means cancel comfort sleep mode.
Operation flow and applicable data, etc.
during pushing CHECK. "B" will
to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
"00" display "B" display
1
B10J2FVG-E B13J2FVG-E
20
44
23
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or
)
1
nearby rooms, this operation prevents the
remote controller signal from being
received simultaneously by both units,
thus preventing both units from operating.
2
3. Operation
The indoor unit on which the remote
controller selection has been set to B
receives the signal of the remote control-
ler also set to B.
(At the factory the remote controller
selection is set to A on all the indoor
units. There is no A setting display.)
2
Quiet mode is the system which, control the
revolving speed of indoor fan to work
constantly at lower than speed L. In addition,
noise level of indoor unit is less than usual.
Remarks :
1. Quiet mode is unable to work in dry mode.
B18J2FVG-E
2. Quiet mode is appropriate to work with less
20 19
44 49
cooling load and less heating load condition.
23 23
Because of the fan speed may not enough
the cooling capacity or heating capacity.
The principles of comfort sleep mode are:
• Quietness for more comfortable. When
room temperature reach setting temperature
• Save energy by changing room temperature
automatically.
• The air condition can shut down by itself
automatically.
Remarks:
1. Comfort sleep mode will not operate in dry
mode and fan only mode.
- 49 -
Description