Harbor Breeze HTD20005 Quick Start Manual page 12

OPERATION INSTRUCTIONS
NOTE:
NOTE: Each transmitter of this remote control carries
a unique ID code to facilitate communication between
paired devices. The ID code is set by factory and is
not user changeable. However, you will be required
to perform an "ID code learning " process manually
under these circumstances:
• If you have multiple fans installed within a close
proximity and want to control all fans using a same
remote transmitter.
NOTE: Each fan requires its own receiver.
•When your remote control is not responding(make
sure battery is not flat)
•After you have replaced a faulty transmitter or
receiver with a new one.
Otherwise the remote control will not work. To perform
this process manually, follow steps below:
After installing and wiring the unit, restore power to
your fan, press and hold the transmitter "
for 5 seconds until the fan beeps to indicate the code
learning process have been completed. This operation
must be completed within 1 minute after restore power
to the fan.
2
3
4
CR2032 3V
" button
12
ON DIM
ON DIM
ON DIM
CR2032 3V