Table of Contents
Advertisement
Mounting the Enterasys Wireless Outdoor APs
The first step to mounting the Enterasys Wireless Outdoor AP is to remove the Wireless AP
housing cover.
Removing the Housing Cover
You have to remove the housing over if you want to carry out any of the following activities:
•
Mount the Enterasys Wireless Outdoor AP to a wall or to the optional mounting plate
•
Connect the power supply cables, Ethernet cable, or external antennas cable to the Enterasys
Wireless Outdoor AP
•
Use the reset button on the Enterasys Wireless Outdoor AP
Figure 2-1
Warning: You must remove the housing cover only after you have turned off the power supply of
the Enterasys Wireless Outdoor AP.
Removing the Housing Cover
• A – Sealing cap
• B – Cover screw
• C – Housing case
Enterasys Wireless Outdoor AP Installation Guide 2-1
2
Advertisement
Table of Contents
