IKA WiCo T25 Easy Clean Control Operating Instructions Manual page 13

Tools:
Tool maintenance time:
In the "Tool maintenance time" menu option, the user can check the tool
maintenance time.
Reset maintenance time:
In the "Reset maintenance time" menu option, the user can reset the tool
maintenance time.
Set maintenance time:
In the "Set maintenance time" menu option, the user can set the tool
maintenance time from 4 to 40 hours.
Timer:
Set Time:
In the "Set Time" menu option, the user can set time from 0 to 99:59:59
[hh:mm:ss] for the dispersing procedure.
Timer Enabled:
In the "Time Enabled" menu option, the user can activate the timer function.
Note: The user can stop the dispersing function before expiry o the set time.
In this case, the countdown of the timer is interrupted.
Operating Mode:
Operating Mode A:
In this operating mode, the set speed is not saved when the current run
comes to an end or the device is switched off.
Operating Mode B:
In this operating mode, the set speed is saved when the current run comes
to an end or the device is switched off, and the value can be changed.
Operating mode C:
In this operating mode, the set speed is saved when the current run comes
to an end or the device is switched off, and the value cannot be changed.
Display:
In the "Display" menu the user can specify what information will be dis-
played on the main screen.
Programs:
Under menu option "Programs", 5 user-defined speed (rpm)-time profiles
can be created. In addition, the user could define the intermittent mode is
activated or not in the programs.
If the intermittent mode is activated, the run time/stop time value from
"Intermittent Mode" setting will be taken.
Note: If user need to activate the intermittent mode in one segment of a
program, he should set the "Run time/Stop time" in menu option "Interval",
meanwhile activate the "Run/Stop" function in menu option "Intermittent
Mode" (see section "Dispersing").
Once a programs has been selected, the following options are available.
Start: Start the selected program upon request.
When the selected program is started by pressing on menu option "Start"
with rotary/push knob, screen reminds the user to confirm the program
control. Then you have to set the loop count. Press "OK" with rotary/push
knob to start the program control.
13