Replacing The Battery - Siemens SICAM AI Product Information

13

Replacing the Battery

Replace the batteries if the battery charge is too low
(avoid full discharge). In this case the "Battery Failure"
operation indication is generated. This message can
also be parameterized on one of the 3 LEDs H1/H2/
ERROR (see device manual
WARNING
Warning of incorrect treatment of the lithium battery
(type PANASONIC CR2032 or VARTA 6032 101 501)
or the use of an incorrect battery type. In the case of
incorrect treatment or the wrong battery type, the bat-
tery may burn, explode or trigger a chemical reaction.
Non-observance may lead to death or serious
injury.
Installing the battery or replacing it may only be car-
ried out by trained personnel (see preface) who are
familiar with and observe the safety requirements
and precautions.
Do not reverse the polarity of the battery.
Do not attempt to open the battery.
Do not attempt to recharge the battery.
Servicing of the circuitry involving the batteries and
replacement of the lithium batteries shall be done by
a trained technician.
Replace battery with VARTA 6032 101 501 or
PANASONIC CR2032 only. Use of another battery
may present a risk of fire or explosion. See manual
for safety instructions.
Caution: The battery used in this device may present
a fire or chemical burn hazard if mistreated. Do not
recharge, disassemble, heat above 100 °C (212 °F)
or incinerate.
Dispose of used battery promptly. Keep away from
children.
SICAM AI Unit 7XV5674, Product Information
E50417-B1150-C492-A1, Edition 09.2012
E50417-G1140-C492).
27