Advertisement
4.
The Remote will then display "Clear
Memory", and ask you to select Yes or
No. If you are happy that the transfer
The logger will display the new date and
was successful, select YES to clear the
time on its top line and "Please Wait" on its
memory. Once you do this then the
second line. You should not try to enter a
only record of the data is on the PC. If
new menu until this has cleared (stopped
you select No; then the memory will
displaying). Otherwise, a message
remain on the remote. You can then
"Comms failure" will be displayed on the
use the remote to again download its
remote.
memory contents to another PC if
required.
Downloading Data From Alarm Logger
to remote Logger
Data logging Software Report
1.
When in 'Download Data Mode' press
the ENTER button. The unit will
immediately try to download all stored
events from the Alarm Logger unit to
the Remote Logger.
2.
If there are no events stored, the
Remote and Logger will display "No
Data Stored". The remote will return to
the menu mode and the logger unit will
return to its main routine.
If there is data to download, the Alarm will
display "Sending data to remote" and the
Remote will display "Receiving data".
Upon completion both units will display
"Download complete" and all data will be
automatically erased from the internal
memory of the Alarm logger in order to free
up space. This is important to note
because once the data has been erased
from the main logger, it can not be
retrieved again from this unit (it will be
stored in the remote for PC download only).
Downloading data to PC
In order to download and record the data
from the Alarm Logger the AirFlow data
logging software must be loaded onto a PC.
Connection to the PC from the Datalogger
is via a 9 pin serial port cable for the data
and USB cable for power.
1.
This mode is used to send to a PC the
data that has been loaded into the
Remote Logger from the Alarm logger.
2.
After the download program has been
launched on the target PC, Press the
ENTER button on the Remote Logger.
The Remote display will show
"Sending data now". The PC will show
a progress bar.
3.
When the transfer is complete the
Remote will display "Download to PC
completed" and the PC will show
"Download completed".
20
Advertisement
