Power Up Your Access Point-I - Avaya AP-1 Getting Started Manual

Install your Access Point-I - Power up your Access Point-I

Power up your Access Point-I

To power up the Access Point-I, connect the unit to a grounding type AC
wall-outlet (100-240 VAC) using the standard power adapter as supplied with
the unit.
Placement must allow for easily disconnecting the unit from the AC wall-
outlet.
When powered on, the unit will perform start-up diagnostics characterized by
a LED sequence. The LEDs will change color in the range Amber, Red and
Green.
When finished (after about 15 seconds) the Access Point-I will start
operation characterized by the LED activity as listed in Table 2-5.
Table 2-5
LED Definition
Power
Ethernet interface
Wireless interface
LED activity will only occur when there is network activity on the
corresponding Access Point-I network interface.
If the Access Point-I does not switch to normal operation within two minutes,
please consult the troubleshooting section of the "Wireless LAN Manager -
User's Guide" (see "Finding Information" on page 1-3).
2-6
LED Activity Table
Activity
Green
Flicker Green
Flicker Green
Access Point-I - Getting Started Guide
Description
Power on
Ethernet LAN activity
Wireless LAN activity