Copy And Paste Buttons; Store Button - Kemper PROFILER The Basics & Profiling Manual

18 KEMPER PROFILER

Copy and paste buttons

(8)
Use the COPY and PASTE buttons to grab a module and copy its data to another similar location. For
example, you can copy and paste the settings of one stomp to another, either within the same rig, or an-
other rig entirely. To do this, select a module and press COPY. Next, select a destination module and press
PASTE. Voilà!
In general, you can use common sense to determine if the PROFILER will let you copy settings from one
module to another. For example, you cannot copy the reverb settings to the amp module. However, it is
possible to copy a Stomp to slot X or MOD in the effects section. Go ahead and try whatever you want;
you will be alerted if what you're attempting is not possible.

Store button

(9)
Use the STORE button on the left side of the display to save any changes you have made to a module or
rig.
STORE allows you to save a rig or a module to the permanent memory.
Pressing Store in Browse mode will offer you three different options using the soft buttons: "Replace"
will overwrite the currently selected rig with the new version while keeping the original name, "Store as"
will save the rig under a new name while keeping the original rig as well, and "Rename" will allow you to
change the name of the actual rig.
When you've got an effects module in focus and press STORE you are given the option to save either the
settings of the currently selected module as a local preset, or to save the entire rig. Choose Soft Button A
to create a new local preset and to dial in an appropriate name.
Your local preset can be found and reloaded later by turning BROWSE, when you have a similar effect in
focus. In the next step you are able to edit the name of the rig.