Copy And Paste Buttons; Store Button - Kemper Profiling Amplifier Manual

Copy and paste buttons

Use the COPY and PASTE buttons to grab a module and copy its data to another similar location. For
example, you can copy and paste the settings of one stomp to another, either within the same rig, or an-
other rig entirely. To do this, select a module and press COPY. Next, select a destination module and press
PASTE. Voilà!
In general, you can use common sense to determine if the KPA will let you copy settings from one module
to another. For example, you cannot copy the reverb settings to the amp module. However, it is possible
to copy a Stomp to slot X or MOD in the effects section. Go ahead and try whatever you want; you will be
alerted if what you're attempting is not possible.

Store button

(9)
Use the STORE button on the left side of the display to save any changes you have made to a module or
rig.
Pressing Store within an edit page will give you the option to save either the settings of the currently-
selected module as a local preset, or to save the entire rig. Make your choice and on the next page, choose
between three different options using the soft buttons. "Replace" will overwrite the currently-selected
rig with the new version. "Store as ..." will save the rig under a new name, and "Rename" will allow you to
change the name of the rig, and then replace the current one with it.
In the next step you are able to edit the name of the rig.
Soft Button #1 Insert
Soft Button #2 Clear
Toggle
Soft Knob #1
Soft Knob #4 Scroll
Press STORE again to complete the procedure.
(8)
a space to the left of the selected character.
the selected space or character.
between upper case and lower case letters.
through the available characters.
FRONT PANEL CONTROLS 17