Table of Contents
Advertisement
Battery Charger
Troubleshooting the Battery Charger
The following table identifies possible battery charger problems and proposed
solutions.
Table 2-3. Battery Charger Problems and Possible Solutions
Symptom
No LEDs on the
battery charger
light.
HANDSET LED on
the battery charger
does not light when
WT is placed into
battery charger.
2-12
Issue 1 May 1999
Possible Causes
Battery charger is
plugged into an
electrical outlet
controlled by a switch
and the switch is
turned off.
WT is not seated
properly in the battery
charger's WT cradle.
Charger AC adapter
is not plugged in.
Contacts in the WT
cradle or on the
battery pack are dirty.
The battery pack is
defective.
Possible Solutions
Plug the battery charger into an
outlet not controlled by a
switch.
Reseat the WT in the battery
charger's WT cradle.
Check that the charger power
cord is plugged into the charger
and into an electrical outlet that
is not controlled by a wall
switch.
1. Verify that there are no
obstructions on the WT or
battery charger contacts.
2. Unplug the charger and
clean the contacts with a soft
eraser.
3. Clean the WT contacts with
a soft eraser.
If you have a fully charged
spare battery pack, use it to
replace the battery pack in the
WT.
1. Place the questionable
battery pack into the battery
charger's spare battery
compartment.
2. Wait one minute. If the
SPARE LED flashes red, order
a new battery pack, or replace
it through maintenance.
Advertisement
Table of Contents
