Table of Contents
Advertisement
7. Pull the small bar (attached to the server) out of the center bar; this takes a little force to
separate them. Set the small bar aside to attach to the rack in a later step.
8. Orient the center bar and large outer bar assembly so that the center bar is facing up.
9. Grasp the center bar with your right hand and the large outer bar with your left hand so that
your left-hand thumb is on the safety latch of the center bar.
10. Press the safety latch, and separate the bars. Set the center bar and large outer bar assembly
aside to attach to the equipment rack in a later step.
11. Prepare the other slide assembly by repeating steps 2–10 above.
Figure 4. Small Rail Extension Release
Figure 5. Center Rail Extension Release
OCPRF100 MP Server System 9
Advertisement
Table of Contents
