Chapter 2
Installing the Power Supply Modules
Installing the VSU-7500
Installing the VSU-7500
This chapter provides instructions for the following:
•
Installing the Power Supply Modules (page 2-1)
•
Rackmount Installation (page 2-2)
•
Connecting the VSU-7500 to the Network (page 2-4)
The VSU-7500 power supply modules are shipped outside the unit. To install the
power supply modules, refer to Figure 2-1 and perform the following steps:
Remove the two power supply modules from their shipping containers.
1.
NOTE: The power supply modules feature autoranging of the source AC line
voltage, thus eliminating the need for a voltage selector switch.
Slide each power supply module into the enclosure and press firmly on the
2.
front of the unit to securely seat the unit. The black spring-loaded retaining
clip should snap when the power supply is locked into place.
Set the ON/OFF (I/O) switch of each power supply module to the ON
3.
position.
2-1