Emerson Rosemount 2160 Quick Start Manual page 12

Quick Start Guide
2.7 Position the antenna
The antenna should be positioned vertically, either straight up or straight
down, and it should be approximately 3 ft. (1 m) from any large structure,
building, or conductive surface to allow for clear communication to other
devices.
Figure 2-4: Antenna Positioned Vertically
2.8 Adjust LCD meter orientation (optional)
If a device display is ordered, it will be shipped attached to the level detector.
The display is ordered in the level detector model number, option code M5.
2.8.1 Rotate the device display
The device display can be rotated in 90-degree increments.
Procedure
1. Squeeze the two black tabs on opposite sides of the display.
2. Gently pull out the display.
3. Rotate the display to the desired orientation, and snap the display
into place.
Note
If the device display four-pin connector is inadvertently removed
from the interface board, carefully re-insert the connector before
snapping the device display back into place.
12 Rosemount 2160 Wireless Level Detector
September 2020