Ac Output Power Wiring - Aerotech UFM-ST Hardware Manual

Installation

2.2.2. AC Output Power Wiring

The UFM-ST three-terminal output connector
AC1 and AC2 are the AC power connections and are wired to the equipment being filtered. The Ground
terminal (connected internally to the Input ground and the external Ground Stud) and is typically connected to
the ground of the equipment being supplied by this filter.
Wiring to the UFM-ST filter must use #16 AWG wires or larger and have an insulation rating of at least 300 V.
www.aerotech.com
(Figure 2-2) is the filter AC output (load) connector. Terminals
AC1 AC2
OUTPUT
100-240V~
50/60Hz
10A MAX
Figure 2-2: AC Output Connections
Chapter 2
UFM-ST Hardware Manual
DANGER!
High Voltage
15