Table of Contents
Advertisement
UFM-ST Hardware Manual
1.3. Mechanical Specifications
Line filters should be located as close to the drive as possible with the case connected through a low
impedance connection to earth ground for maximum effectiveness. The unit should be mounted to earth
ground, where possible, with M4 (#8) mounting hardware.
19.4 [0.77]
13.2 [0.52]
12
Ø4.7 [0.19] (TYP 4 PLS)
38.4 [1.51]
50.8 [2.00]
77.2 [3.04]
Figure 1-3:
Chapter 1
REC. MTG. HDWR.: M4[#8]
DRAWING NUMBER: 630D2192C
DIMENSIONS: MM [INCHES]
UFM-ST Dimensions
Introduction
80.9 [3.19]
39.7 [1.56]
#10-32 GROUND STUD
www.aerotech.com
Advertisement
Table of Contents
