Chauvet Professional WELLPANEL Quick Reference Manual page 7

Main Level
Red Shift
Master/Slave
Dimmer Mode
Dimmer Curve
White Balance
Manual
LED
Frequency
Receive On/Off
Wireless
Setting
Receive Reset
Line Voltage
Power Loss
Mode
Run Time
Back Light
Key Lock
Fixture Hours
Information
Factory Reset
WELL Panel QRG Rev. 6
QUICK REFERENCE GUIDE
Programming Levels
On
Off
Master
Slave
Off
Dimmer 1–3
Linear
Square
I Squa
Scurve
Off
Red
Green
125–255
Blue
White
600Hz
1200Hz
2000Hz
4000Hz
6000Hz
25KHz
On
Off
No
Yes
Stay In State
All At Full
Dim Out
Off
3 Hours
5 Hours
8 Hours
12 Hours
10S
30S
2Min
Always On
On
Off
<_ _ _ _H> Shows total hours the product has been powered on
Version <V_._>
UID <_ _ _ _ _ _> Shows product UID
No
Yes
Description
Turns on or off Red Shift (amber LEDs imitate lamp when
dimming)
DMX mode (Master)
Slave mode
Linear dimmer
Dimming curves Dimmer 1 (fast) to Dimmer 3 (slow)
Liner dimmer
Square curve dimmer
Reverse square curve dimmer
S curve dimmer
Uses factory default white setting
Sets red LED maximum value
Sets green LED maximum value
Sets blue LED maximum value
Sets white LED maximum value
Sets the PWM frequency
Enables/disables wireless DMX
Resets wireless receiver
If line power is lost, the fixture will continue to function as
programmed under battery power (default)
After 5 seconds of line power loss, all LEDs will go to full power
(returns to normal operation when line power is restored)
After 5 seconds of line power loss, the LEDs will dim in a 10
second fade to black (returns to normal operation when line
power is restored)
Maximum intensity for all LEDs
Reduced intensity, limiting battery run time to 3 hours
Reduced intensity, limiting battery run time to 5 hours
Reduced intensity, limiting battery run time to 8 hours
Extends battery to the maximum run time of 12 hours
Turns off display backlight after 10 seconds of inactivity
Turns off display backlight after 30 seconds of inactivity
Turns off display backlight after 2 minutes of inactivity
Display backlight always on
Locks display (password is <UP>, <DOWN>, <UP>,
<DOWN>, <ENTER>)
Shows current firmware version
Resets the product to factory default settings
EN
6