Remote Panic Operation; Remote Starting The Vehicle - Audiovox PRO9675FT4 Owner's Manual

2. Turn the ignition switch 'on" then 'off'.
3. Within 10 seconds of turning off the ignition, move the valet switch "on", "off", "on", "off",
"on", "off".
4. If the chirps were on before you started, the siren will emit 2 short chirps indicating that the
chirps are now off. If the chirps were off before you started, the siren will emit one short
chirp indicating that the chirps are now on.
NOTE: If the vehicle battery is disconnected then reconnected, the unit will return to the default
setting of chirps on. Repeat the above proceedure to eliminate the arm/disarm chirps.

REMOTE PANIC OPERATION

The Lock/Unlock button of your keychain transmitter also serves as a panic switch and will
turn the alarm on from the maximum operating range of the transmitter. In an emergency
situation, to use the panic feature, press and hold the Lock/Unlock button of your keychain
transmitter for 3 seconds. This will cause the lights to flash, the siren to sound, and if the
optional interior illumination circuit was installed, the interior light will flash.
To disengage the panic feature, press and release Lock/Unlock button. If you do not shut off
the panic feature, the system will time out and shut off automatically after 30 seconds.
During this mode, all normal transmitter functions are operational.
SAFETY (Red Handled ) CONTROL SWITCH
The control switch allows you to temporarily disable the remote starting function of your
PRO-9675FT. For safety, this switch must be turned off for vehicle servicing. To disable the
unit, move the red handled control switch to the off position.
The control switch also allows you to select between 2 hour start up and 4 hour start up when
using the automatic start up timer mode. The factory preset start up time for this mode is every
4 hours. To select between 2 or 4 hour start up timer:
1. Begin with the control switch in the on position
2. Turn the ignition switch on then off
3. Within 10 seconds, move the control switch off, on, off, on (2 switch cycles) to select a
2 hour start timer. After 10 seconds expire, the parking lights will flash and the siren will
chirp 2 times confirming that the two hour start cycle is set. Or, within 10 seconds move
the control switch off, on, off, on, off, on, off, on (4 switch cycles) to select a 4 hour start
timer. The parking lights will flash and the siren will chirp 4 times confirming that the 4 hour
start timer is set.

REMOTE STARTING THE VEHICLE

The PRO-9675FT WILL NOT start the vehicle if any one of the following conditions exists:
1. The Vehicle Hood Is Opened.
2. The Gear Selector Is In Any Gear Other Then Park.
3. The Brake Is Depressed.
4. The Safety Control Switch Is In The Off Position.
CAUTION! Be certain that the vehicle is outdoors before using this or any remote vehicle
starting device. A running engine produces dangerous carbon monoxide fumes
which can be harmful or fatal if prolonged exposure occurs. DO NOT remote
start the vehicle if it is garaged.
To Remote Start The Vehicle:
Press and release channel 2 of your keychain transmitter two times within 2 seconds. The
vehicle will start and remain running for the pre-programmed 10 or 15 minutes. As a visual
Page 5
128-5370
5 of 8