Steelcase Amia 482 Replacement

Chair - arm or arm cap

Hide thumbs Also See for Amia 482:

Download this manual

If you have a problem, question, or request, call

your local dealer, or Steelcase Line 1 at

888.STEELCASE (888.783.3522)

for immediate action by people who want to help you.

(Outside the U.S.A., Canada, Mexico, Puerto Rico,

and the U.S. Virgin Islands, call: 1.616.247.2500)

Or visit our website: www.steelcase.com

Grand Rapids, MI 49501

U.S.A.

Printed in U.S.A.

™

482 Amia

Chair - Arm or Arm Cap Replacement

Torx T-20 & T30

or a flat-bladed

screwdriver that is 8"

or longer

Page 1 of 5

939548205 Rev B

Need help?

Do you have a question about the Amia 482 and is the answer not in the manual?

Page 1 8" or longer If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S.
Page 2: Arm Replacement
Arm Replacement Locate the white quick release tab located on the left hand side of the chair (as you sit in it) between the plates. Lift the quick release tab (2a) while REAR lifting the seat slide lever (2b) and sliding the seat forward &...
Page 3 SCREW Remove two (2) screws on each arm. Remove old arms. Install new arms. SCREW Install two (2) screws on each arm. Torque to 25-35 in/lbs. Page 3 of 5 939548205 Rev B...
Page 4 Align seat with chair control and engage slots on the bottom of the seat with the tabs located on the seat bearings (7a). Slide seat fully backward while holding up on the seat slide lever (7b). SLOT ON BOTTOM TAB ON BEARING OF CHAIR SEAT SLIDE LEVER...
Page 5 Arm Cap Replacement To remove arm cap, remove four (4) screws (1a) and remove cap from arm (1b). To replace arm cap, reverse steps 1a and 1b and tighten screws to 6-10 in/lbs. When installing, make sure to align the ribs on the two (2) screw bosses of the arm cap to the rear of the arm.