Section 3 - Configuration
Use this page to enable an alarm when a signal from an external device connected
to the NVR's Alarm In interface is detected.
Select the channel to configure.
Alarm In
Toggle this to enable or disable Alarm In events and alarms.
Enable Alarm
In
Select the event(s) the alarm should trigger from the following
Event Actions
list:
•
Email: Send an email notification
•
Buzzer: Trigger a buzzer sound
•
Popup Message: Display a notification in a popup window
Trigger a notification on the Alarm Out interface(s).
Enable Alarm
Out
Toggle to keep a record of alarm events.
Enable Event
Recording
Enable or disable the alarm according to a particular schedule.
Detection
Schedule
Specify the normal state of the sensor. A change from this state will
Normal State
trigger the alarm.
Designate a name for the sensor.
Port Name
Click this tab to configure similar settings for sensors connected to
Camera Alarm
a camera's Alarm In interface.
In
D-Link DNR-4020-16P User Manual
Alarm In
42