Setting Up Your Dnr-4020-16P (Web Gui) - D-Link DNR-4020-16P User Manual

Section 2 - Installation

Setting Up Your DNR-4020-16P (Web GUI)

You can connect PoE network cameras directly to your DNR-4020-16P using the 16 PoE ports on the rear panel.
For non-PoE network cameras, you will need to locate power outlets in the on-site environment then run a CAT5E UTP cable
to the LAN ports on the NVR.
You can set up your NVR via the web UI. To do this, connect an Ethernet cable to the LAN port on the rear panel of the device.
Connect the other end of the cable to an Ethernet port on your switch, router, or computer.
D-Link DNR-4020-16P User Manual 80