QDI PlatiniX 1D Series Manual page 23

Enable Front/Back Panel USB Device Wake-up Function (JFUSB/JUSB)
The mainboard provides the advanced USB device wake-up function. The system can be
waked up from its power saving including ACPI S3 by activating USB device. Before using
this function, set JFUSB/JUSB with pin1 & pin2 closed. Otherwise, set JFUSB/JUSB with
pin2 & pin3 closed for disabling. Furthermore, the item “Wake-Up From S3 by USB”in BIOS
setup should also be set corespondingly to enable or disable this function.
JFUSB
BIOS Protection Jumper (JAV)
The BIOS of the mainboard is inside the FWH. If the jumper JAV is set as closed, you will
be unable to flash the BIOS to the mainboard. However in this status, the system BIOS is
protected from being attacked by serious virus such as CIH virus.
The mainboard provides the BootEasy function.If you want to use this function,Please
set the jumper JAV as open under PC will boot-up in normal way conditions. Refer to
the BootEasy introduction.
JUSB
Disable:
Enable:
(Default)
Flash Write Disabled
Flash Write Enabled
(Default)
Manual for P1D series
Chapter 2
1
1
2 2
3 3
JUSB JFUSB
1
1
2
2
3
3
JUSB JFUSB
1
2
JAV
1
2
JAV