Husqvarna T 4000 Petrol Workshop Manual page 18

17. Install the spring pins in the 2 holes. This locks the
guard for the fan to the engine plate.
18. Make sure that the distance between the field plate
and clutch element is correct. Refer to
close the air gap at the magnetic clutch on page 19
19. Install the clutch guard (A) and tighten the 4 screws
(B).
B
18 - Repair and servicing
20. Connect the cable for the engine START/STOP
switch.
21. Install the throttle wire on the bracket (C).
To open or
A
22. Install the bracket and tighten the bolt (D).
23. Install the ground wire, the washer and the nut.
Tighten the nut.
D
C
1331 - 001 -