Honda WT30XK4 Manual page 55

GOVERNOR SYSTEM
GOVERNOR ARM/CONTROL BASE
GOVERNOR SYSTEM
REMOVAL/INSTALLATION
Remove the following parts.
– Air cleaner (page 6-5)
– Muffler (page 14-2)
– Fuel tank (page 6-3)
After installation, adjust the maximum speed (page 7-4).
GOVERNOR ROD/THROTTLE
RETURN SPRING
REMOVAL/INSTALLATION:
Pull the carburetor (1) away from
the engine to a point where the
groove (2) of the throttle arm lines
up with the governor rod (3), and
then lift the governor rod out of the
hole of the throttle arm and unhook
the throttle return spring (4).
(4)
(1)
7-2
BOLT (6 x 12 mm) (2)
(3)
(2)
CONTROL BASE
GOVERNOR SPRING
INSTALLATION:
Install with the long end
of the spring toward the
control base assy.
Hook the governor spring
to the outer hole of the
governor arm.
OUTER HOLE
NUT (6 mm)
GOVERNOR ARM
GOVERNOR ARM
BOLT
GOVERNOR ARM
SHAFT