Honda WT30XK4 Manual page 50

CARBURETOR DISASSEMBLY/ASSEMBLY
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
To prevent serious eye injury, always wear safety
goggles or other eye protection when using
compressed air.
Tampering is a violation of Federal and California law.
Remove the carburetor (page 6-6).
Before disassembly, clean the outside of the carburetor.
PILOT JET SET
ASSEMBLY:
Before installing, clean
thoroughly with a jet
cleaning tool, carburetor
cleaner, and low-pressure
compressed air.
Lightly lubricate the O-ring
to ensure easy installation
into the carburetor body.
MAIN NOZZLE
ASSEMBLY:
UPPER SIDE
Before installing, clean
thoroughly with a jet
cleaning tool, carburetor
cleaner, and low-
pressure compressed air.
MAIN JET
ASSEMBLY:
Before installing, clean thoroughly
with a jet cleaning tool, carburetor
cleaner, and low compressed air.
FLOAT CHAMBER
ASSEMBLY:
Install the float chamber to the
carburetor body at an angle as shown.
20°
NOTE 1
NOTE 2
NOTE 3
SET COLLAR
THROTTLE STOP SCREW
NOTE 1:
O-RING
PILOT SCREW
NOTE 2:
LIMITER CAP
UPPER SIDE
FLOAT PIN
SET SCREW GASKET
IDLE SPEED ADJUSTMENT
PILOT SCREW REPLACEMENT
CUP FILTER REMOVAL/INSTALLATION
O-RING
CHOKE LEVER
DRAIN SCREW
SET SCREW
FUEL SYSTEM
SCREW(3 x 6 mm) (2)
LEVER SETTING PLATE
VALVE LEVER SPRING
FUEL COCK LEVER
FUEL VALVE PACKING
SPRING PIN (2 x 12 mm)
CUP FILTER
NOTE 3:
O-RING
SEDIMENT CUP
3.9 N·m (0.4 kgf·m, 35 lbf·in)
FLOAT VALVE
FLOAT
FLOAT VALVE SPRING
O-RING
DRAIN SCREW GASKET
page 3-9
page 6-9
page 3-6
6-7