Honda WT30XK4 Manual page 53

FUEL SYSTEM
CHOKE SET REPLACEMENT
Remove the carburetor (page 6-6).
Pull out the choke valve plate (1).
Remove the choke shaft (2) and install a new choke
shaft.
Insert a new choke valve plate into the slit (3) of the
choke shaft.
Be sure the choke shaft is in the position between the
projections (4) of the choke valve plate.
Operate the choke lever (5) and check for proper choke
plate operation.
CYLINDER STUD BOLT
REPLACEMENT
Thread two nuts onto the stud bolt and tighten them
together, and then use a wrench to turn the stud bolt
out.
Install new stud bolts.
SPECIFIED LENGTH
WT30XK4:
STUD BOLT (8 x 123.0):
WT40XK3:
STUD BOLT (8 x 131.5):
6-10
107.0 mm (4.21 in)
115.5 mm (4.55 in)
(2)
(4)
(1)
WT30XK4:
STUD BOLT (8 x 123.0): 107.0 mm (4.21 in)
WT40XK3:
STUD BOLT (8 x 131.5): 115.5 mm (4.55 in)
(5)
(3)
(1)
(2)
(4)