Honda WT30XK4 Manual page 116

BALANCER WEIGHT BEARING (6202)
(WT40XK3 ONLY)
Pull out the radial ball bearing (1) using the special
tools.
TOOLS:
Bearing remover head, 15 mm (2) 07936-KC10200
Bearing remover shaft, 15 mm (3) 07936-KC10100
Remover weight (4)
Apply oil to the circumference of a new bearing (5).
Drive the radial ball bearing until it is fully seated on the
end using the special tools.
TOOLS:
Attachment, 32 x 35 mm (6)
Pilot, 15 mm (7)
Driver (8)
GOVERNOR ARM SHAFT OIL SEAL
(8 x 14 x 5 mm) (WT40XK3 ONLY)
Remove the oil seal from the cylinder barrel.
Apply grease to the lip of a new oil seal (1).
Drive the oil seal in the position as shown using the
special tools.
TOOLS:
Pilot, 14 mm (2)
Driver (3)
07936-371020A
07746-0010100
07746-0040300
07749-0010000
07746-0041200
07749-0010000
OIL SEAL RIP
CRANKCASE
(3)
(4)
(2)
(1)
(8)
(6)
(7)
(3)
(2)
0 – 0.5 mm
(0 – 0.02 in)
(5)
(1)
13-21