Audio/Modem Riser Interface Connector(Amr); Chassis Security Switch (Chssec); Infrared Header (Irda) - QDI KinetiZ 7A Manual

Installation Instruction
Audio/Modem Riser Interface Connector (AMR)
The AMR Interface Connector is the interface between the mainboard and the Audio/Modem
Riser card. The connector provides all necessary signals which supports several different
configurations of audi o and modem in the system, such as audio and modem on the Riser,
audio on the mainboard and modem on the Riser, or no audio with modem on the Riser.
KinetiZ 7A mainboar d provides you with audio onboard solution, onboard audio can be
enabled/disabled. Either AMR (Audio/Modem Riser) card or MR (Modem Riser) card can be
used on this system. This software configurable AC'97 audio and modem sys tem gives
customers an advanced, mul t imedia solution at an extremely low price. The AC'97 audio and
modem system can be enabled/disabled in "Integrated Peripheral s " in AWARD BIOS CMOS
Setup.
AMR Interface Connector

Chassis Security Switch (CHSSEC)

The connector connects to the c hassis sec urity switch on the cas e. The sy stem can
detect the c hassis intrusion thr ough the status of this connector. If the c onnector has
been closed once, the s ystem will record the status and indicate the chassis has been
opened. You can receive this information from QDI ManageEasy software.

Infrared Header (IrDA)

This connector suppor ts wir eless trans mitting and receiv ing. If using this func tion, set
"UART 2 Mode" to HPSIR or ASKIR and configure the settings from the "INTEGRATED
PERIPHERALS" section of the BIOS.
Manual for KinetiZ 7A