Rockwell Automation Allen-Bradley 1606-XLE96B-2 Reference Manual

Reference Manual
Bulletin 1606 Switched Mode Power Supplies
Catalog Number: 1606-XLE96B-2
Index
1. Intended Use .......................................................3
2. Installation Requirements ...................................3
3. AC-Input...............................................................4
4. DC-Input...............................................................5
5. Input Inrush Current ...........................................5
6. Output .................................................................6
7. Hold-up Time .......................................................7
8. Efficiency and Power Losses................................8
9. Functional Diagram.............................................9
10. Front Side and User Elements .............................9
11. Terminals and Wiring ........................................10
12. Reliability ...........................................................10
13. EMC ....................................................................11
14. Environment ......................................................12
15. Protection Features ...........................................13
16. Safety Features ..................................................13
17. Dielectric Strength ............................................13
18. Certifications .....................................................14
Terminology and Abbreviations
• PE and symbol-PE is the abbreviation for Protective Earth and has the same meaning as the symbol
• Earth, Ground-This document uses the term "earth" which is the same as the U.S. term "ground".
• T.b.d.-To be defined, value or description will follow later.
• AC 230V-A figure displayed with the AC or DC before the value represents a nominal voltage with standard tolerances (usually ±15%).
included. E.g.: DC 12V describes a 12V battery whether it is full (13.7V) or flat (10V).
• 230Vac-A figure with the unit (Vac) at the end is a momentary figure without any additional tolerances included.
• 50Hz vs. 60Hz-As long as not otherwise stated, AC 230V parameters are valid at 50Hz mains frequency.
• may-A key word indicating flexibility of choice with no implied preference
• shall-A key word indicating a mandatory requirement
• should-A key word indicating flexibility of choice with a strongly preferred implementation.
a P e g
19. Environmental Compliance ............................. 14
20. Physical Dimensions and Weight ..................... 15
21. Accessories ........................................................ 16
22. Application Notes ............................................. 17
22.1. Peak Current Capability ...........................17
22.2. Back-feeding Loads ..................................17
22.3. Charging Batteries
22.4. External Input Protection .........................18
22.5. Inductive and Capacitive Loads ................18
22.6. Parallel Use to Increase Output Power ....19
22.7. Parallel Use for Redundancy ....................19
22.8. Daisy Chaining of Outputs .......................20
22.9. Series Operation .......................................20
22.10. Use in a Tightly Sealed Enclosure ............20
22.11. Mounting Orientations ............................21
a P e g
...............................18
.