8-Care And Cleaning - Haier HW80-B14979 User Manual

EN
8.1 Cleaning the detergent drawer
Take always care there are no detergent residues.
Clean the drawer regularly (Fig. 8-1):
1. Pull out the drawer until it stops.
2. Press the release button and remove the drawer.
3. Flush the drawer with water until it is clean and
insert the drawer back in the appliance.
8.2 Cleaning the machine
Unplug the machine during cleaning and mainte-
nance.
Use a soft cloth with soap liquid to clean the ma-
chine case (Fig. 8-2) and rubber components.
Do not use organic chemicals or corrosive sol-
vents.
8.3 Water inlet valve and inlet valve fi lter
To prevent blockage of water supply by solid substanc-
es like lime clean regularly the inlet valve fi lter.
Unplug the power cord and turn off the water
supply.
Unscrew the water inlet hose at the back (Fig.
8-3) of the appliance as well as on the tap.
Flush the fi lters with water and a brush (Fig. 8-4).
Insert the fi lter and install the inlet hose.
8.4 Cleaning the drum
Remove accidentally washed items, especially met-
al parts such as pins, coins, etc. from the drum (Fig.
8-5) because they cause rust stains and damage.
Use a non-chloride cleaner for removing rust
stains. Observe the warning hints of the cleaning
agent manufacturer.
Do not use any hard objects or steel wool for
cleaning.

8-Care and cleaning

2
1
3-Control panel
EN
Séchage Dry Level Fin différée Delay Temp. T emp. Temp.
Stain removal S tain removal Taches i-Refresh i-Refresh S team Rinçage + Essorage Extra Rinse Extra Rins e S peed Speed
525 DRUM REFRESH
Cotton Coton Synthetics Synthétique Duvet Couette Laine Wool Délicat Delicate Séchage Smart Lavage et Wash and Dry
séchage
Express
Bébé Coton Babycare Mix Mixte 15 min Express 15 Fast Rapide Dry Essorage Coton 20 Spin Eco 40-60 Eco 40-60
1 "Power" button Display Function buttons
3 5
2 Programme selector 4 Detergent /Softener drawer 6 "Start/Pause" button
Note : Acoustic signal
In following cases, an acoustic signal is no sounds by default:
when pressing a button
at the end of programme
when turning the programmes selector
The acoustic signal can be selected if necessary ; see DAILY USE(see P17 6.13).
3.1 "Power" button
3-2
Touch this button (Fig. 3-2) gently to switch on, the
display is shining, the indicator of the "Start/Pause"
button is flashing. Press it again for about 2 seconds
to switch
activated after a while machine will shut down auto-
3-3
matically.
3.2 Programme selector
By turning the knob (Fig. 3-3) one of 14 programmes
can be selected, related LED will light up, its default
settings will be displayed.
3.3 Display
The display (Fig. 3-4) shows following information:
3-4
Washing time
Delay Temp.
End time delay
Stain removal Steam Ex tra Rinse Speed
Error codes and service information
8-3
8-1
8-2
8-4
8-5
19