Haier HW80-B14979 User Manual page 17

EN
6.10 Start wash programme
Touch "Start/Pause" button (Fig. 6-8) to start. The
LED of the "Start/Pause" button stops fl ashing and
lights up continuously
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
6.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is fl ashing. Press it again to resume operation.
To cancel a running programme and all its individual settings
1. Touch "Start/Pause" button to interrupt the running programme.
2. Touch "Power" button for about 2 seconds to switch the appliance off .
3. Touch the " Power" button to turn on the appliance, run programme Spin and select
"no Speed" (speed lights are off ) to drain the water.
4. After closing the programm to restart the appliance,select a new programme and start it.
6.12 After washing
Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; 
1. At programme cycle end  is displayed.
2. The appliance switches off automatically.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4. Turn off the water supply.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the program or at the end of program. The display switsches
off . This saves energy. To interrupt the standby mode push "Power" button.
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the MIX programme.
3. Touch the "Delay"button and "Temp." button at the same time for about 3 seconds.
" " will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. " " will
be displayed.
is displayed

6-Daily use
3-14
6-8
17