Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Genexis XG Series
Summary of Contents for Genexis XG Series
- Page 1 XG–Series Installation Guide...
- Page 2 Button overview Port overview ON/OFF LAN ports switch WAN/SFP port Reset button Power port CATV Reset button (recessed) ON/OFF switch Reset – press 5 seconds and release Power ON or OFF – switch device ON or OFF...
- Page 3 LED overview Power (PWR) Green – system ok – boot failed – power off Green –1Gb link established Green (blinking) – indicate traffic Yellow – 100Mb link established Yellow (blinking) – indicate traffic – no WAN connected Green – 1/10Gb link established Green (blinking) –...
- Page 4 Installation guide Different language versions of this document and additional product information are available on https://genexis.eu/download-portal/#XG Box contents Preparation • XGX (active device) Ensure there is a power socket • Power adapter within reach of where the device • RJ45 Network cable (2x) is being installed and that the product •...
- Page 5 Troubleshooting Setting up the XG Is the Power (PWR) indicator LED off? 1. Connect the RJ45 network cable to • Check if the device is properly connected to the power adapter. the internet LAN port. • Check if the power adapter is connected to an electrical outlet. 2.
- Page 6 EU Declaration of Conformity Hereby, Genexis B. V . declares that the product XG6846B is in compliance with Directives 2014/30/EU, 2014/35/EU, 2011/65/EU, Delegated Directive 2015/863 and Ecodesign Directive 2009/125/EC. The full text of the EU declaration of conformity is available at the following internet address: https://genexis.eu/red/XGX...
- Page 7 Revision 1.0 - June 2020 - Copyright © 2020 Genexis B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the XG Series and is the answer not in the manual?
Questions and answers