Genexis FiberTwist XGS2110 Installation Manual
  1. Manuals
  2. Brands
  3. Genexis Manuals
  4. Network Router
  5. XGS2110
  6. Installation manual

Genexis FiberTwist XGS2110 Installation Manual

Hide thumbs Also See for FiberTwist XGS2110:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

FiberTwist
XGS2110
Installation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FiberTwist XGS2110 and is the answer not in the manual?

Questions and answers

Related Manuals for Genexis FiberTwist XGS2110

Summary of Contents for Genexis FiberTwist XGS2110

  • Page 1 FiberTwist XGS2110 Installation Guide...

  • Page 2: Button Overview

    Button overview Unlock button Remove FiberTwist or Blind Cover – press and hold while twisting counterclockwise Reset button (recessed) Reset - press and release Factory reset - press and hold the button until System and Uplink LED start to blink LED dim button Dim LEDs –...

  • Page 3: Port Overview

    Port overview LED overview Power port System ON/OFF LAN port Green – system ok button Green (blinking) – booting Red - system or boot failure Red (blinking) - insufficient PON signal Off – power off Uplink Green – link ok Green (blinking) –...
  • Page 4 Installation guide Box contents Remove Blind Cover (if present) • Genexis FiberTwist (active device) Important: Instructions 1. Press and hold the unlock button (see button overview). • Power adapter need to be followed 2. Rotate the Blind Cover counterclockwise till it blocks.
  • Page 5 Remove dust cap Twist! 1. Take the FiberTwist out of the box. 1. Place the FiberTwist on the FTU as shown in the picture below, 2. The dust cap is connected to the red string in a 30–degree angle. located on the rear of the FiberTwist. 2.

  • Page 6: Safety Guidelines

    To the extent permissible by applicable law, failure to follow these 2. Connect the supplied power adapter to the FiberTwist and plug the adapter into a guidelines could result in damage to your product, which might not be covered by Genexis warranty. power socket.
  • Page 7 • When connecting an electronic device to the product, make sure to use the recommended To reduce potential damage to the equipment, observe the following recommendations: network cable and connect the device to the right port of the product. Incorrect connections •...

  • Page 8: Supplier's Declaration Of Conformity

    Supplier’s Declaration of Conformity 47 CF $ 2.1077 Compliance Information Responsible Party – U.S. Contact Information Testing Partners LLC, 18200 SR 306, Chagrin Falls, OH 44023 info@testingpartners.com FCC Compliance Statement The FiberTwist-XGS2110-US-1 has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
  • Page 9 Revision 2.0 - October 2023 - Copyright © 2023 Genexis Netherlands B.V. All rights reserved. Multiple languages of this document and additional product information are available on https://genexis.eu/product/fibertwist/downloads Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.

Table of Contents