Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Genexis Pure Series
Summary of Contents for Genexis Pure Series
- Page 1 Pure ED500 Pure-Series Installation Guide...
-
Page 2: Port Overview
LED & button overview Port overview Status Reset button Green – power on The reset button resets the modem to factory Reset button Green (blinking) - booting settings. You can press this button with a – boot failed small pin or paperclip. Press and hold the WAN port button for more than 10 seconds. - Page 3 ”POWER” at the 1. Make sure the WiFi icon on the front panel • Genexis Pure ED500 2. Use the drilling guide to drill the holes, back of the Pure ED500. is lit. If not, press the Mode button for 10 •...
-
Page 4: Troubleshooting
Is the Status indicator LED off? Reset the device Hereby, Genexis B. V . declares that the radio equipment type Pure ED500 is in compliance with Check if the modem is properly connected The reset button resets the modem to factory Directive 2014/53/EU. - Page 5 Revision 1.1 - December 2019 Copyright © 2019 Genexis B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the Pure Series and is the answer not in the manual?
Questions and answers