Malfunctions Documentation Accessories; Error Messages On The Control Unit - Leica PROVEO 8 User Manual

What to do if ...?

14.2 Malfunctions documentation accessories

Malfunction
Video pictures unfocussed.

14.2 Error messages on the control unit

When the control unit detects an error, the yellow "Check" button lights up.
Press the "Check" button.
X
The list with error messages is displayed.
To acknowledge a message, select the message and press the "Confirm" button.
X
When there is no error message pending, the yello "Check" button disappears.
Error code Source
0112h PROVEO 8 Optics
0116h PROVEO 8 Optics
0402h Slitlamp adapter
FE01h MDC
FE02h MDC
FE03h MDC
FE04h MDC
FE06h MDC
FE07h MDC
66
Cause
Microscope or fine focus not precisely focussed.
Visible for user Meaning
yes Main LED overtemperature
yes RedReflex LED overtemperature
yes Lamp defective
yes Optics carrier not found
yes XY controller not found
yes F42 controller not found
yes Slitlamp adapter not found
yes DIC800 not found
yes HDR not found
PROVEO 8 / Ref. 10 733 910 / Version 02
Remedy
Focus precisely, use graticule if necessary.
X
Perform diopter correction exactly
X
according to the instructions.
Possible cause of error
• Main LED too hot.
• No air flow possible.
• Opitcs Carrier might be covered.
• RedReflex LED too hot.
• No air flow possible.
• Opitcs Carrier might be covered.
Lamp defective
• CAN connection loose.
• Cable damaged.
• Controller defective.
• CAN connection loose.
• Cable damaged.
• Controller defective.
• CAN connection loose.
• Cable damaged.
• Controller defective.
• CAN connection loose.
• Cable damaged.
• Controller defective.
• No slitlamp adapter installed (Device list not correctly
configured).
• CAN connection loose.
• Cable damaged.
• Controller defective.
• No DIC800 installed (Device list not correctly
configured)
• RS232 connection loose.
• Cable damaged.
• Controller defective.
• No IVR850 installed (Device list not correctly
configured).