Casio 5602 Operation Manual page 42

Location Indicator
Q1
Location Indicator does not appear
on the display.
Is the watch paired with a phone?
The watch needs to be paired with a
phone for Location Indicator to work. Pair
the watch with a phone.
Pair the watch with a phone.
l C
Is Location Memory information being
recorded?
Location information needs to be
recorded in Location Memory for Location
Indicator to work. Record location
information in Location Memory.
Recording Your Current Location
l
(Location Memory)
Are phone settings configured to acquire
location information?
The phone needs to be used to allow use
of PRO TREK Connected location
information for Location Indicator to work.
Allow use of location information.
Are phone settings configured to acquire
GPS information?
You may experience problems acquiring
GPS information in environments like the
ones described below.
Where the view of the sky above is
●
narrow
Near trees or buildings
●
Near a train station, airport, or other
●
congested areas
Locations where there is heavy traffic
●
and radio wave interference
Near railway aerial wires, high-voltage
●
lines, TV towers, etc.
Signal reception is not possible in the
locations described below.
Where the sky is not visible
●
Underground, in a tunnel, under water
●
Indoors (Reception may be possible
●
near a window.)
Near radio communication equipment
●
or other devices that generate
electromagnetic waves
Operation Guide 5602
Barometric Pressure
Measurement
Q1
Following a relative barometric
pressure reading, the watch's
second hand points to 9 o'clock.
The second hand will move to 9 o'clock if a
reading is outside the allowable barometric
pressure measurement range (260 hPa to
1,100 hPa (7.65 inHg to 32.45 inHg)). If [ERR]
appears on the display, there may be a
problem with the sensor.
Checking the Change in Barometric
l
Pressure between Two Readings
Q2
[ERR] appears during measurement.
There may be a problem with the sensor. Try
taking another measurement. If [ERR] keeps
appearing after multiple measurement
attempts, contact a CASIO service center or
your original retailer.
Temperature Measurement
Q1
[ERR] appears during measurement.
There may be a problem with the sensor. Try
taking another measurement. If [ERR] keeps
appearing after multiple measurement
attempts, contact a CASIO service center or
your original retailer.
World Time
Q1
The time for a World Time City is not
correct.
The summer time setting (standard time/
summer time) may be wrong.
Specifying a World Time City
l
Pedometer
Q1
Displayed step count is not correct.
While the watch is on your wrist, the
pedometer may detect non-step movements
and count them as steps.
Pedometer
l
Also, step count problems can also be caused
by how the watch is being worn and abnormal
arm movement while walking.
Causes of Incorrect Step Count
l
Q2
The step count does not increase.
To avoid miscounting of non-walking
movements, the step count is not displayed at
the beginning of a walk.
It appears only after you have continued
walking for about 10 seconds, with the number
of steps you took during the first 10 seconds
included in to the total.
Q3
[ERR] appears when using the
pedometer.
[ERR] (error) indicates that sensor operation
is disabled because of sensor or internal
circuitry malfunction.
If the indicator remains on the display for more
than three minutes or if it frequently appears,
it could indicate a faulty sensor.
Contact a CASIO service center or your
original retailer.
Alarm
Q1
The alarm does not sound.
Is the alarm setting turned on? If it isn't, turn it
on so it will sound.
Configuring Alarm Settings
l
42