Configuring Alarm Settings
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (A) and (C) to display the number
([AL1] to [AL5]) of the alarm whose
settings you want to change.
Alarm number
Alarm time
3.
Hold down (E) for at least two seconds.
Release the button when the hour setting
starts to flash.
The
(alarm) indicator is displayed
●
when any alarm is turned on.
Hours
4.
Use (A) and (C) to change the hour setting.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (D).
This causes the minutes digits to flash.
Minutes
6.
Use (A) and (C) to change the minute
setting.
7.
Press (E) to complete the setting
operation.
8.
Hold down (D) for at least two seconds to
return to the Timekeeping Mode.
Operation Guide 5602
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
You can also use PRO TREK
●
Connected to configure alarm time
settings.
Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (A) or (C) to display the hourly time
signal screen ([SIG]).
3.
Press (E) to toggle the hourly time signal
between enabled (on) and disabled (off).
(hourly time signal) is shown on the
●
display while the hourly time signal is
enabled.
Note
You can also use PRO TREK
●
Connected to configure the hourly time
signal setting.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (A) and (C) to scroll through alarm
numbers ([AL1] to [AL5]) and the hourly
time signal ([SIG]) screens until the one
whose setting you want to change is
displayed.
Alarm number or hourly time signal
3.
Press (E) to turn off the displayed alarm or
the hourly time signal.
Each press of (E) toggles between ON
●
and OFF.
Turning off all alarms will cause
●
(alarm) to disappear from the display,
while disabling the hourly time signal
causes
(hourly time signal) to
disappear from the display.
32