USC Surge Hopper Operator's Manual page 25

Inspect all welds and structural components for bends, cracks, and damage.
•
Clean out any build up of debris.
•
Test slide gate for proper actuation with 3-Way valve.
•
Drain water from compressor daily.
•
Drain air dryer every 40 hours of operation.
•
Inspect all welds and structural components for bends, cracks, and damage.
•
Test diverter K-Valve for proper actuation with 3-Way valve.
•
Clean diverter of any obstructions.
•
Grease both K-Valve bearings.
•
Inspect all welds and structural components for bends, cracks and damage.
•
Check for binding on scale components.
•
Check wiring from scale to scale head for any damage or kinks.
•
Have scale professionally re-calibrated as necessary.
•
WEIGH HOPPERS & SURGE HOPPERS
HOPPER
SLIDE GATE & AIR SYSTEM
DIVERTER
SCALE & SCALE HEAD
Page 25