Maintenance Schedule; Disinfecting And Cleaning - Ferno 175 Series Technical Service Bulletin

Maintenance Schedule

The fastening system requires regular maintenance. Set up and follow a
maintenance schedule. The table at right represents minimum intervals
for maintenance. Keep maintenance records.
When using maintenance products, follow the manufacturers' directions
and read the manufacturers' material safety data sheets.

Disinfecting and Cleaning

To disinfect: Wipe all surfaces with disinfectant. Follow the
●
disinfectant manufacturer's instructions for application method
and contact time. Inspect the fastening system for damage as you
disinfect it.
To clean: Hand clean all surfaces of the fastening system with
●
warm water and a mild detergent. Rinse with warm, clear water.
Dry with a towel or allow the fastening system to air-dry.
Lubricating the Jaw Shaft
Disinfect and clean the fastening system before applying lubricant.
To lubricate the jaw shaft, push the release handle until the jaws lock
in the unlocked (open) position. Apply a small amount of WRL-191-S or
white lithium grease to the shaft of the movable jaw (Figure 14).
After applying lubricant, cycle the jaw a few times, using only the cot to
activate the detent button.
Do not use your fingers to activate the detent button.
●
Do not use Teflon or silicone-based lubricants.
●
8
Ferno Technical Service Bulletin
MODEL 175 MAINTENANCE
WARNING
Improper maintenance can cause injury. Maintain the
fastening system only as described in this service bulletin,
or the users' manual.
Pressing the detent button with your fingers can cause
injury. Use caution when lubricating the jaw shaft. Always
use the cot to activate the detent button.
Table 3 - Minimum
Maintenance
Disinfecting (this page)
Cleaning (this page)
Lubricating (this page)
Routine Inspection (page 9)
Important
Disinfectants and cleaners containing bleach, phenolics, or
iodines can cause damage. Do not use products containing
these chemicals.
Using abrasive cleaning compounds or applicators on the
fastening system can cause damage. Do not use abrasive
materials to clean the fastening system.
Using Teflon or silicone-based lubricants can lead to silicone
buildup on parts, causing damage. Use only the lubricants
specified in this service bulletin or the users' manual.
Each Use As Needed
•
•
•
•
© Ferno-Washington, Inc. / 234-3601-00
14