Installation Drawings/Dimension Sheets; Information On The Installation Drawings - Siemens Simotics T-1FW6 Configuration Manual

Installation drawings/dimension sheets

9.1

Information on the installation drawings

Fastening holes
The schematic representation below shows the position tolerance for fastening holes
according to EN ISO 1101:2008-08. The diameter "d" of the circular tolerance zone indicates
the tolerance.
Figure 9-1 Position tolerance for fastening holes
The actual position of the hole's mid-point (actual dimension) must lie within the circular
tolerance zone to enable the motor components to be attached without any problems. If no
specific value has been stated, the standard tolerance of d = 0.2 mm (as used by the
machine tool industry) applies.
1FW6 external rotor built-in torque motors
Configuration Manual, 12/2020, A5E50516483B AA
9
161