Programming The Wireless Siren; Wireless Siren Alarm Settings; Program Wireless Smart Socket - KERUI KR-K7 User Manual

Programming the wireless siren

To program the wireless siren press the set button for 3 seconds until the indicator light is on. It is now
in program mode that will last about 20 seconds. In the wireless siren page of the panel, switch
'wireless siren' on or off, the host will send a signal; wireless siren will be ringing sound "DiDi" and
flashing 2 times after receive the signal. exist the programming state by press the set button of the
wireless siren.
Check if programming was successfully: after the wireless siren exist program state, on the wireless
siren page of the panel, switch 'wireless siren' on or off, if it is off, "DiDi" sound; if it is on, the wireless
siren will alarm, which means the programming was successfully.

Wireless Siren Alarm settings

In Wireless Siren page there is the ability to switch the wireless siren on or off, and press [OK] to save.
The default status is on.
If the wireless siren is on, the wireless siren will alarm when the host alarms, and the alarm will stop if
the panel is disarmed or panel stop alarm.
If the wireless siren is off, the wireless siren will not alarm when the panel alarms.

7.6 Program Wireless Smart Socket

To program the smart socket set it on standby mode state by press and hold the setting button until
the indicator light is off. In the smart socket page of the panel, switch [smart socket] on or off, the host
will send a signal and the indicator of smart socket will flash two times after received the signal
meaning the programming was successfully. Press the setting button of the smart socket to exit the
standby mode.
Check if programming was successfully: after the smart socket exits the program state, switch
[wireless socket] on or off, if it is off, the indicator light will be red; if it is on, the indicator light will be
blue, which means its programs successfully.
KR-K7 User manual
18