Delete Remote Control; Remote Control Snd Sound; Sensors; Add Sensors - KERUI KR-K7 User Manual

Hide thumbs Also See for KR-K7:

Table of Contents

Delete Remote Control

Delete remote control in single zone: after enter remote control page as shown in Picture4-4, select

the zone needed to be deleted and press key [OK],or delete all the remote controls by press key

[DELETE ALL] at the top-right corner.

As shown in Picture 7-1, on the remote control learning page you can switch on/off the sound.

Selecting 'Sound ON' the external siren shall beep "Di Di" when the remote control in this zone is used

to arm or disarm. Factory default of the sound is ON.

Note: there are two kind of host sirens: one is host horn siren called 'built-in siren', the others are the

external wired siren and wireless siren, called 'external siren'.

As shown in Picture 7-2 there is a total of 99 zones (split up in 17 pages), and each zone displays the

number of sensors learned (xx Pcs), siren state (on/off), zone attribute and event code.

To enter the sensor learning page select one of the zones. Within the zone page press the 'ADD'

button to start the learning mode as shown in Picture 7-3. At this moment, trigger the sensor to send a

signal to host. The host voice prompts "Add, successfully programmed" and the sensor and number is

displayed on the screen, which means the sensor has been added and is programmed to the host. If

there is a voice prompt "Configured" when triggering the sensor it means that the sensor was already

added to the host and couldn't be programmed repeatedly. The host can learning 99 different sensors

in total.

KR-K7 User manual

Picture 7-2

Table of Contents

Show Quick Links

Table of Contents