Controls And Indicators - Audio Pro STEREO ONE User Manual

CONTROLS AND INDICATORS

HEAD UNIT
FRONT PANEL
1) Power switch
Press this button to turn on the receiver, provided it
is in standby mode (indicated by the red LED on the
ace-bass indicator (#19 on the diagram). If it is not illu-
minated, then the receiver is turned off, in which case,
turn on the ON/OFF switch at the back of the unit (ON).
The power switch is also used to place the receiver in
standby mode. NOTE! The ON/OFF switch at the back
of the unit turns it off completely. In standby mode, the
unit can be turned on and off with the remote control.
The latter procedure will not work if the ON/OFF switch
on the back of the unit is turned off. (OFF)
2) Source (selection of audio source)
Turn this dial to select the audio source (CD/Radio/
AUX or Line-in) on the front of the receiver. The source
will be indicated briefly on the display (15).
3) Display
Press this button to change the operation indicator on
the display (15), for example, time, audio source, or
choice of RDS modes in the radio position. See page
14.
4) Play/Pause CD
Press this button to play a CD. Make sure there is a CD
in the tray (16). Push the Play button again to pause
the CD. By pushing the Play button again, the CD will
begin playing from the point at which it was paused.
6
5) Stop/Memory
CD mode: Press the button to stop playing the CD.
Tuner mode: Press the button to open the internal
memory for radio pre-sets.
6 & 7) Search/Auto tuning
CD mode: press (7) to search forward in the track
that is being played and press (6) to search backward
in the track that is being played.
Tuner mode: press (7) to automatically search the
next radio station up the dial. Press (6) to automati-
cally search the next radio station down the dial.
8) Menu
Press to set the TIME and TIMER modes. See pages
11 and 17.
9) Tone/Skip/Balance/Preset
Press this button to select the mode to be adjusted:
BASS, TREBLE, S. DIRECT or BALANCE (these
words will appear on the display).
Adjust the levels by turning the knob to the left to de-
crease or to the right to increase. The adjustment will
appear on the display.
CD mode: turn the knob to the right to select the next
track. Keep turning the knob to scan forward to sub-
sequent tracks. Turn the knob to the left to listen to
the same track over again. Continue to turn the knob
to select earlier tracks.