Adjusting The Sound - Audio Pro STEREO ONE User Manual

ADJUSTING THE SOUND

Adjusting the volume
Turn the volume knob clockwise (to the right) to
raise the volume or counter-clockwise (to the left)
to lower the volume.
The scale shown on the display ranges from 00-
40, that is, from VOL OO (minimum) to VOL MAX
(maximum).
Always check the volume setting before an audio
source is turned on. Turn the volume knob all the
way down before unplugging headphones.
Example: display showing the volume at 20.
Muting (Only possible with the remote control)
The volume can be turned off temporarily with the
muting function on the remote control. Press the
MUTING button on the remote control to turn the
audio off temporarily. During MUTING, the display
will blink. Press the MUTING button again to
return to the previous volume (Only possible from
the remote control). The muting also stops if the
volume knob setting is changed.
Adjusting the bass
Press the TONE/SKIP/BAL button until BASS
appears on the display. After a few seconds, turn
the same knob clockwise (to the right) to increase
the bass or counter-clockwise (to the left) to de-
crease the bass. The normal position is indicated
by BASS O.
Example: bass set at +2.
Adjusting the treble
Press the TONE/SKIP/BAL button until TRE ap-
pears on the display. After a few seconds, turn
the same knob clockwise (to the right) to increase
the treble or counter-clockwise (to the left) to de-
crease the treble. The normal position is indicated
by TRE O.
Example: treble set at -1.
16
Playback without the tone settings
Press TONE/SKIP/BAL button until S.DIRECT appears
on the display. Immediately, all of the tone settings will
be switched off. Playback occurs without the tone set-
tings. The TONE indicator is turned off on the display.
To return to the previous tone settings, move forward
to BASS.
Playback returns to the tone settings and the TONE
indicator is lit on the display.
Example: S. DIRECT selected.
Adjusting the balance between the left and right
channel
Press the TONE/SKIP/BAL button until the L00-00R
indicator appears on the display. Then, turn the same
knob clockwise (to the right) to decrease the left
channel or counter-clockwise (to the left) to decrease
the right channel. The normal position is indicated by
LOO-OOR.
Example: normal balance position.
Note:
When the TONE/SKIP/BAL button is pressed, the last
function selected is displayed. Continue pressing the
button until the desired function is displayed.
Once a function has been selected, the adjustment
must take place in a few seconds.