Using The Remote Control; Setting The Clock; Connecting An External Audio Source - Audio Pro STEREO ONE User Manual

INSTALLATION

Using the remote control

Insert the AAA batteries included in the packaging
into the battery opening on the back of the remote
control. Make sure that the polarities (+ and -) are
aligned correctly.
The remote control's operating range (approxi-
mate)
Note that the remote control's power button only
works if the power switch on the back of the head
unit is in the ON position and the LED on the front
of the panel is red. Weak batteries will affect the
range of the remote control.
Setting of the clock
When the unit is used for the first time, or if it is
turned off with the ON/OFF switch, or if there has
been a power outage, no time will appear on the
display (the clock can also be set from the remote
control). Skip points #1 and #2 if the unit is in
standby mode.
1) Press the MENU button.
2) Turn the TONE/SKIP knob to the right until SET
TIME appears.
3) Press MENU again. Turn the TONE/SKIP knob to
the left or right until the correct time appears. On
the remote control, use the PRESET buttons.
4) Press the MENU button once more; the clock is
now set.
Note! Adjusting the time with the remote control
occurs in 10-minute intervals when the PRESET
button is held down. During standby mode, the
time is always shown on the display. There are
three levels of brightness. Select a level by press-
ing on the DISPLAY button (only in standby mode).
The clock can also be set automatically when a
radio station with the RDS/CT function is selected.
.
Connecting the FM indoor antenna
Connect the FM indoor antenna plug to the output on
the back panel.
Locate the other end where the reception is good.
Connect a central or outdoor antenna here too.
Connecting the AM antenna
Connect the AM antenna wires according to the figure
below.
Place the ring as far from the unit, TV, and power cables
as possible. Adjust the placement of the ring for the
best possible reception.

Connecting an external audio source

Connect an external audio source with RCA plugs to
AUX on the back panel or with a 3.5 mm [1/8 inch] plug
to LINE IN on the front panel. Select the respective
audio source with SOURCE on the front panel or INPUT
on the remote control.
AUX IN on the back panel LINE IN on the front
11