Toshiba G7 Series Applications Workbook page 40

Programming
Direct Parameter Path
Access
F411 Program Motor
Settings
F412 Program Motor
Settings
F413 Program Motor
Settings
F014 Program Fundamental
Parameters Frequency Setting
F400 Program Motor
Motor Model
F115 Program Terminal
Terminals
F420 Program Torque
Parameters Torque Control
F214 Program Torque
Parameters Setpoints
F425 Program Torque
Speed Limiting
F426 Program Torque
Speed Limiting
F427 Program Torque
Speed Limiting
F428 Program Torque
Speed Limiting
Start and run the motor in speed control mode to verify operation. Reduce speed to zero Hertz. If
you are using the demo terminals strip, close switch S1. Otherwise, you will need to make a dry
contact between S1 and CC. This will put the drive into torque control mode.
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-2192
efesotomasyon.com -Toshiba inverter,drive,servo,plc
Parameter Name
Parameters Motor Number of Motor Poles
Parameters Motor Rated Capacity of Motor
Parameters Motor Motor Type
V/f Pattern
Parameters Vector Autotune
Selection Input S1 (or other discrete input
terminal)
Setting Torque
Selection
Setting RR
Setting Torque Forward
Selection
Setting Torque Forward
Level
Setting Torque Reverse
Selection
Setting Torque Forward
Level
Comments
Configure the number of motor poles to
match that of the motor used
Rated capacity of the motor is kW.
determine kW if Hp is known, multiply Hp
by 0.745
If motor used is not listed as a possible
selection, use 'Other'. and perform autotune
as last step.
Select either 'Sensorless Vector Control
(speed)' or 'Sensorless Vector Control
(speed/torque switching)'
Select 'Reset Motor Defaults'. The G7 will
then apply the correct motor model.
Select #56: Control Switch (torque,postion)
Command Set to source of torque command. RR used
is this example
Scale RR input as required.
Speed Limit Select 'SETTING'
Speed Limit Set to desired maximum output frequency in
forward direction while in torque control
mode
Speed Limit Select 'SETTING'
Speed Limit Set to desired maximum output frequency in
reverse direction while in torque control
mode
To
40