Toshiba G7 Series Applications Workbook page 24

Hide thumbs Also See for G7 Series:

Connection

Note: The above diagram shows connections to use a single meter for either the FM or AM outputs

with a selector switch determining which output the meter will display. This is not a required setup

and two separate meters may be used to read the two separate outputs.

Programming

Before programming,

1.) Refer to the table above and select the desired drive attribute to output. If more than two outputs are

needed, and extender board must be installed. This board will provide two extra outputs Analog1

and Analog2.

2.) Determine which output terminals will output which drive attribute and connect meters

appropriately.

3.) Determine whether the output is to be 0-1[mA] or 4-20[mA] and set the switches above each

terminal appropriately.

Parameter

FM Terminal

AM Terminal

ANALOG1

ANALOG2

For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-2192

efesotomasyon.com -Toshiba inverter,drive,servo,plc

Program → Meter Terminal Adjustment

Location

Parameters →FM

New Value

Desired output for

FM Terminal

Desired output for

FM Terminal

Desired output for

Analog1 Terminal

Desired output for

Analog2 Terminal

H7 series